Muzzoom Lipo Saddle Holder (Procat / Bosscat / CAT2000)

For: Schumacher Procat, Bosscat & CAT2000*

3D printed cradles and straps with stainless steel hardware to hold hardcase lipo saddle batteries in the Schumacher Procat and Bosscat. 

With a simple adjustment, these holders can also be used with Low Centre of Gravity saddle lipos. 

Please specify the type of screw fitment you require from the options list:

• Slot (To suit early Procats)
• Pozi (To suit later Procats and Bosscats)
• Hex (To suit modern builds)
• Hex Countersunk (To suit thicker carbon chassis with countersunk bottom holes)

*Note: Depending on the fitment of your bodyshell on the CAT2000, one screw may be very close to the shell. It is therefore recommended that either a strip of protective foam is stuck to the inside of the shell or the excess screw thread be trimmed off.