UA-134753204-1

V2_Lipo Shorty Holder for CAT

MUZ-200202a

***Revised Version***

For Schumacher CAT SWB, XL and XLS (both original and re-release) with the standard stick pack chassis.

Designed by Dan Ferguson, these holders allow secure fitment of hard case shorty lipo packs into the Schumacher CAT SWB, XL and XLS buggies, when fitted with the standard stick lower chassis.

The lipo is positioned approximately 8mm further rearward than the re-release Masami XLS design, keeping weight distribution as intended on the original and also leaving more room for electrics.

Avoids the need to drill unsightly holes in original chassis plates.

Does not require any modifications to fit:

Step 1: Select the holder with the central clip and slot the tabs under the 'ears' of the chassis where the original battery holders would sit on the motor side. Clip into place.

Step 2: Slide in your hardcase shorty lipo.

Step 3: Select the remaining holder and slot the tabs under the 'ears' of the chassis on the spur gear side, then twist upright against the lipo.

Step 4: Clip the supplied O-ring over the tabs on both holders, ensuring the o-ring passes underneath the top deck.

To remove the lipo, just release the o-ring and remove the spur side holder only.

Earn 0 reward points
£0.00 £19.00
QTY:
Out Of Stock
Add To Wishlist